{
  "bibcode": "2007GCN..6946....1G",
  "body": "Neil Gehrels (NASA-GSFC) reports on behalf of the Swift team:\n\nThis is an update on Swift status following earlier Circulars\n(Gehrels 6760; Barthelmy et al. 6781; Burrows et al. 6791;\nGehrels 6825).  As of today, Swift is re-enabled for full-time\nautonomous GRB slewing.  The gyro problems of the past 2 months\nare resolved and the observatory is back to slewing accurately\nwithin its 3 arcmin requirement.  BAT and XRT continue to be\nfully operational and performing science, as they have been for\nseveral weeks.  UVOT is in engineering mode, and will be activated\nfor science observations in the middle of next week.  The TOO web\nsite is back on line.\n\nMore details on the problem and solution are as follows:  On\nAugust 10 gyro #3 (known as Two Axis Rate Assembly - TARA 3)\nexhibited jumps in its bias offset level (voltage output when gyro\nis not rotating) that caused the spacecraft to go into safe hold.\nRedundant TARA 2 was switched in for recovery.  It was then found\nthat TARA 2 is slightly misaligned from TARA 1, with the consequence\nthat slew accuracy was degraded.  Due to memory limitations of the\nonboard spacecraft computer, assumptions were made in the matrix\nmanipulation mathematics that did not permit a simple correction\nfor the misalignment.  However, a clever technique was found by\nCraig Markwardt to use available parameters to combine signals\nfrom all 3 gyros for accurate slewing.  This mode of operation,\nwhich is now the baseline, is called TARA 123 and uses TARA 3 to\ncorrect the TARA 1 and 2 alignments.  The TARA 3 term comes in at\nlow weight and, as such, is not sensitive to its small bias shifts.\nA more elaborate software patch has been developed that could be used\nin the event of a failure of TARA 3.",
  "circularId": 6946,
  "createdOn": 1192829488000,
  "email": "gehrels@milkyway.gsfc.nasa.gov",
  "subject": "Swift autonomous slewing re-enabled",
  "submitter": "Neil Gehrels at GSFC  <gehrels@milkyway.gsfc.nasa.gov>"
}